Modified on: Tue, 25 Jun, 2019 at 5:44 PM
This video will show you how to install the Honeywell LT-Cable into your Honeywell LYNX Touch L5210 wireless security system.
To install the Honeywell LT-Cable simply depress the two tabs located at the top of the touchscreen exposing the insides of the Honeywell L5210 wireless security system. After the panel has been opened make sure the backup battery and any other form of power is unplugged. Locate your 300-04705 transformer and take the the Honeywell LT-Cable wire leads, find the black wire with the fork, slide the black wire fork under the negative end of the transformer. Locate the red wire on the Honeywell LT-Cable and slide that wire under the positive end of the the transformer. Now that you have secured the Honeywell LT-Cable to the 300-04705 transformer its time to run the male end of the Honeywell LT-Cable and run it through the back of the Honeywell L5210 system. Once you have done that insert the male end of the Honeywell LT-Cable into the female port of the Honeywell L5210 system. Next, plug in your alarm backup battery and seal the panel up. The Honeywell L5210 will begin its booting process press and hold the home button for 3 seconds, this will allow you to begin manipulating your system. Thats how you install the Honeywell LT-Cable into your Honeywell LYNX Touch L5210 wireless security system.
The Honeywell LT-CABLE comes with about 7 and half feet of cable for your DIY installation of your wireless security system. The most beneficial reason to go with the Honeywell LT-Cable is the positive and negative ends of the wire come ready with forks that slide directly into the positive and negative ends of the 300-04705 transformers that come with the Honeywell LYNX Touch L5210 wireless security system. The opposite end of the Honeywell LT-Cable is a male end that directly plugs into the Honeywell LYNX Touch L5210 wireless security system. With these two features in action with the Honeywell LT-Cable you wont have to worry about purchasing 22 gauge by 2 wire from the local hardware store, stripping, crimping or hard wiring cables for power to your DIY security system.
If you are looking to have your power transformer ran further than 7 and half feet than you will have to go the other route which is where you use either 18, 20 or 22 gauge by 2 conductor wire which runs from the power transformer to the wireless security system providing power to your DIY system. The only other option is to select a different location to mount your Honeywell LYNX Touch L5210 wireless security system.
For the lowest No-Term alarm monitoring rates contact GEOARM Security 1-877-443-6276.
Honeywell LYNX Touch L5210 Frequently Asked Questions "FAQ'S"
Alarm Monitoring: http://bit.ly/geoarmmonitoring
Geoarm Security Blog: http://bit.ly/DIYSECURITYBLOG
Honeywell L5210: http://bit.ly/LYNXL5210
Did you find it helpful?Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.
Do You Have any Discussion Comments?
comments powered by Disqus